Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Heater fault Error.

    Scheduled Pinned Locked Moved
    Duet Hardware and wiring
    2
    3
    105
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Hiroakiundefined
      Hiroaki
      last edited by

      When it's idle, the heater works ok, but when started printing it shows Heater fault error in a few minutes.(or sometimes in a few seconds)
      Sometimes it continues up and down about +-20 Degree C.
      I thought that the FET for heater 1 has a problem and changed the config setting to use heater 2. But the result is the same.
      Does anyone had the same problem ?

      1 Reply Last reply Reply Quote 0
      • Vetiundefined
        Veti
        last edited by

        sudden drops or spikes indicate a wiring problem. check the crimping on the cable.

        or move the cables by hand

        Hiroakiundefined 1 Reply Last reply Reply Quote 0
        • Hiroakiundefined
          Hiroaki @Veti
          last edited by

          @Veti Hello.
          Thank you for your comment.
          I will check it.
          Regards

          1 Reply Last reply Reply Quote 0
          • First post
            Last post
          Unless otherwise noted, all forum content is licensed under CC-BY-SA