After Micro swiss DD upgrade,Extruder skips steps
-
remove M401 and M402 from Bed.g
M92 X79.92 Y79.84 Z797.61 E277.89 ; set steps per mm
are you sure those measurements are correct and backlash did not play a part in it?
-
i have remove the M 401 and 402 from bed.g
i dont think because after a restart and start printing it will use mesh.
the rest of config is fine ?
-
config otherwise looks fine.
as i said execture each step from the beginning of the g code file and see with M122 after each if mesh is enable, to see where it gets disabled.
-
@lui2004 said in After Micro swiss DD upgrade,Extruder skips steps:
G1 H2 X4 Y4 F600; move slowly 6mm in +X and +Y directions
It's a minor thing, but you should remove the H2 from that line in your homeall.
Were you perhaps printing an older gcode file that didn't have G29 S1 in it?
-
-
Yes.
The H2 means to move without regard to endstop, which is fine for the Z axis because it hasn't been homed yet, but in the case of the X Y axis it should already be homed, so normal movement should work fine. If for some reason the homing move failed, the H2 would still allow the axis to move, which can make for a confusing error.
-
@Phaedrux said in After Micro swiss DD upgrade,Extruder skips steps:
Were you perhaps printing an older gcode file that didn't have G29 S1 in it?
after a restart it works all fine with mesh active
-
-
yes that is a very good benchy
-
Great looking prints.
-
