How to configure a CoreXYUV
-
I finished the hardware built of my Corexyuv 3 d printer. Similar to Deckingman (Ian), my printer consist of an XY gantry and a UV stacked gantry in vertical direction. Every gantry uses its own homing endstops. I started configuring the Duetfirmware. Iām using the Duet 3 and 3 6HC expansion boards. I have been trying to find guidance on the forum and on Dozuki, but not sucessfull.
Does anyone know where to find guidance on having the uv following the same movements as xy?
Kind regards,
Harald
-
Paging @deckingman
-
@Phaedrux said in How to configure a CoreXYUV:
Paging @deckingman
I'm on the case but currently floating around on a boat with no WiFi and very limited phone coverage. Harald knows I'll sort him out but I can't do much until next weekend.
-
Phaedrux, I did contact Ian already, but did not wanted to tell the world, Ian's whereabouts.
Was hoping something existed.
I will wait until Ian is back, enjoy your time Ian -
@ahwitmer In the meantime, can you email me a list showing which motor is connected to which driver on which board. E.g. X motor, main board, driver 0. V motor, expansion board 1,driver 2. etc..
