firmware and filling of DUET 2

sergei

I do it in the configurator. but i have a problem with temperatures

Veti

you really need to give more information we can not guess what is wrong
be as detailed as possible.

sergei

when i create firmware in configurator. Then I write it down to a USB flash drive and insert it into the board. then when I turn it on, the temperature of the table and extruders is 2000 degrees. And I also turn on the remote by entering the ip address and there the temperature is constant at 89 degrees.
you can look here is the ip address 192.168.0.52

sergei

Veti

@sergei

post your config.

sergei

This post is deleted!

sergei

config.g config.json

Veti

are you sure that you have installed firmware 3.1.1?

also
B1504
that is no thermistor that i know of.

sergei

So here I am and ask for help as I'm new to this and don't understand anything

Veti

please read
https://duet3d.dozuki.com/Wiki/Installing_and_Updating_Firmware

i would also suggest your read this guide on how to go about it carefully
https://duet3d.dozuki.com/Guide/Ender+3+Pro+and+Duet+Maestro+Guide+Part+1:+Wiring/37

sergei

na plate proshivka vrode 2.01

sergei

and you won't be able to configure the file ?

Phaedrux

@Veti said in firmware and filling of DUET 2:

i would also suggest your read this guide on how to go about it carefully
https://duet3d.dozuki.com/Guide/Ender+3+Pro+and+Duet+Maestro+Guide+Part+1:+Wiring/37

I would suggest you go through these guides to see how reprap firmware and the duet are used in practice. It may help you understand what's going on. It goes through connections, updating firmware, getting a config file set, and initial testing and calibration.

sergei

Tell me how to connect and make BL Touch work

Veti

sergei please consult the documentation

https://duet3d.dozuki.com/Wiki/Connecting_a_Z_probe

in most cases you will find documentation about the things you need to do
(btw this is also the first page that you get in google if you type in duet bltouch)

sergei

Help. I can't understand why the printer's speed drops when printing in two colors

sergei

the extruder feeds the filament at a very high speed

Phaedrux

We can't see what's happening, you'll have to show us the gcode being used. Everything in RRF is controlled by gcode, so if the printer is doing something, it's because it was commanded to with gcode. So show us the gcode and we can see what is happening.

sergei

[0_1603342686044_newtest2cveta.gcode](Uploading 100%)

Veti

@sergei
please wait after reaching 100% the file was not attached