Corexy X moves back and y moves across

[npm1]

Please help

I paired the wires by using a multimeter.
At one point, and with no changes to the wiring everything worked perfectly with the correct movements.

At one I end up with error short to ground and at another point phases a and b may be disconnected I no longer get this but the motors do vibrate and no longer move smoothly.

Please help
I'm using 3.1.1

[whosrdaddy]

Check your wiring for bad crimps. If you feel your wiring is correct and sound it could be that a driver failed, in that case try using another driver (but make 100% sure your wiring is correct)

[JoergS5]

@npm1 if the motors vibrate and don't move, it could be too high current setting for the drivers in the config also, M906.

[Phaedrux]

Please post your config.g, homing files, and the results of sending M122 and M98 P"config.g" in the gcode console.

[matt3o]

do you have a duet3 by any chance? (it could be this https://forum.duet3d.com/topic/18011/duet-3-6hc-short-to-ground-issue )

[npm1]

All sorted now with working bltouch

I realised that after a while y axis driver was creating alot of problems so am now using E1 for y instead....

Thanks for all the help

[npm1]

The board was completely gone with nothing being functional as it should