Bed Levelling using 3 z motors and 1 z probe issues

Veti

@shaunppl said in Bed Levelling using 3 z motors and 1 z probe issues:

RRF 3.01

please update to 3.1.1

shaunppl

Sorry my fault, I did upgrade to 3.11 thought it was still on 3.01

Veti

@shaunppl said in Bed Levelling using 3 z motors and 1 z probe issues:

G10 P0 X40 Y40 Z0 ; set tool 0 axis offsets

Tool 0 should not have an offset.

revert this to X0 Y0

shaunppl

That makes no difference And i have changed it to 0:0, as soon as the P4 starts the process, the motors move the x and y to positions, but on the way the x grinds into the end stop and keeps trying to to move in that direction and not the X30 position, when it goes to the front stepper screw position it then does the same for the Y Endstop until i have to hit the Stop button.

Veti

@shaunppl said in Bed Levelling using 3 z motors and 1 z probe issues:

G31 P500 X40 Y40 Z2.5 ; set Z probe trigger value, offset and trigger height
G30 P0 X20 Y300 Z-99999 ; probe near a leadscrew

Next issue.
you say probe at X20
With an offset of X40 the nozzle would have to go to X-20 to probe there.

same for Y

shaunppl

OK what a twat should have noticed that, thanks, forgot to make notes before update and lost all my config files,

When it finished the probe (after changing to the correct parameters) it does not adjust the leadscrews to make up the bed being uneven ??, it just displays the warning that there are differences that exceed the limits.

Veti

@shaunppl said in Bed Levelling using 3 z motors and 1 z probe issues:

M671

see
https://duet3d.dozuki.com/Wiki/Gcode#Section_M671_Define_positions_of_Z_leadscrews_or_bed_levelling_screws

the S parameter

shaunppl

Yet again what a savior, I am making notes now as not to get lost, very new to 3.11 so again many thanks for your help.

Veti

@dc42 this seems link a bug though. G30 should not allow movements outside of the axis limits

A Former User

@Veti said in Bed Levelling using 3 z motors and 1 z probe issues:

G30 should not allow movements outside of the axis limits

G32 moves my nozzle outside the axis limits when executing.

Veti

@dc42 can we get your input here?

fcwilt

@Veti said in Bed Levelling using 3 z motors and 1 z probe issues:

@dc42 this seems link a bug though. G30 should not allow movements outside of the axis limits

From the documentation:

Caution: the XY coordinates are permitted to be outside the normal printable bed area! This is intentional, because some printers (e.g. delta printers) benefit from probing areas not used for printing.

Frederick

Veti

@fcwilt
thanks i did not read that.