Where are the instruction to setup with the user interface ??
-
Serious lack of information, when you follow the whole thing you end up at the user interface with no information on how to go further.
Issues with RRF Config tool :
-Heaters Output are wrong (listed from 0 to 2, while listed 1-3 on the board)
Can't get any voltage on heaters whatever setting I try
-Z-Probe Assignment input pin ALWAYS go back to blank
-Heaters in Fans and Tools page are listed as BED even if only 1 nozzle is setup ???? -
Error on the 6hc board:
led's for endstop are NOT working
led's for heaters are NOT working. -
