Duet2 Wifi need to be repaired, not under warranty
-
All the LEDs are ok, without the blue LED of wifi in standalone.
5V is external, and 24V VIN is commanded by PS_ON.
with 24V VIN off :
with 24V VIN forced to on, VIN LED bright low.
With USB, I could communicate by yat, M122 respond by exemple.
-
if you're lucky all you need is a new sd card socket. the leds on the ends stops are on, are they working if you look at the machine properties or use
M119?You'd probably need to strip the board down and use some more light to get a good picture to evaluate
-
Are you watercooling the drivers on the Duet?
-
@warpster yes, drivers and processor.
-
I'm all for over the top, but why?!
-
@bearer said in Duet2 Wifi need to be repaired, not under warranty:
if you're lucky all you need is a new sd card socket. the leds on the ends stops are on, are they working if you look at the machine properties or use
M119?You'd probably need to strip the board down and use some more light to get a good picture to evaluate
Somebody know the reference of the microSD card socket ?
-
@Phaedrux said in Duet2 Wifi need to be repaired, not under warranty:
I'm all for over the top, but why?!
Because I need to have the whole printer inside the enclosure, which goes to 50 degrees inside.
The fanless psu and the hotend are water-cooled too.And for the fun !!!!!!
-
Fair enough.
-
This post is deleted! -
@pipersw said in Duet2 Wifi need to be repaired, not under warranty:
reference of the microSD card socket
https://www.digikey.com/product-detail/en/w-rth-elektronik/693071020811/732-693071020811CT-ND/11631970 is the new recommendation from Duet3D
(But afaik the footprint is quite common for a 9-pin SD socket)
((However maybe complete the diagnostics before ordering parts?))
(((in general https://duet3d.dozuki.com/Wiki/Connector_and_spare_part_numbers )))
-
@bearer thanks
