Any full working Ender 5 Plus configurations?

Phaedrux

If you post your config and homing files we can probably get you sorted out. What firmware version are you using?

catsandicecream

I put my config up here -
https://github.com/yincrash/Ender-5-Plus---Duet-2-Wifi-or-Ethernet-Configuration

And made a tiny tester @ 0.24mm layers that has a bit of stringing with PLA, but otherwise reasonably solid. I may tweak my PrusaSlicer settings.

Tiny_Tester-e5.gcode

How can I determine what are my max speeds for my axes and are there any optimizations I forgot? I think I will also re-use the bed mesh saved to disk instead of constantly probing the bed every run. Also, when doing the top layer, the extruder skipped a bit. Not sure if that's from my slicer settings or the extruder rate in config.

Phaedrux

I think you've got an ok start. If you've already got it printing that's 90% of the battle.

Check this out: https://forum.duet3d.com/topic/14250/tuning-jerk-accel-speed-settings/2?_=1586651239957

catsandicecream

@Phaedrux said in Any full working Ender 5 Plus configurations?:

https://forum.duet3d.com/topic/14250/tuning-jerk-accel-speed-settings/2?_=1586651239957

Thanks

Additionally, has anyone tried making the existing touch screen panel work? I'm assuming it's the same touch screen in the CR-10S Pro, the model on the panel says "dmt48270c043_06wt". It seems to be a commodity panel, but I assume Creality put some sort of firmware on it for easy communication between the panel and the main board

conorsmyth

Hi, did you get this working in the end. I'm trying to do the same. I was also wondering if you put the second z motor into one of the extruder slots or did you somehow wire the motors together to the same driver?

Either way I'd look forward to hearing how it turned out

leewaa

Old topic but possibly valuable information available on this, hence a thread revival/bump.

@catsandicecream did you end up making progress on this ?

Reine

If someone has a working config I would be interested in having a look as I'm in the process of converting my Ender 5+.

droomoo

I also would be interested in a config dump as I have an Ender 5 Plus I want to convert as well.

catsandicecream

Sorry, I don't have notifications turned on. I'm finally upgrading to RRF 3.x, and will have an updated configuration once I have everything working again.

catsandicecream

I've updated my config for RRF 3.x and updated it on GitHub - https://github.com/yincrash/Ender-5-Plus---Duet-2-Wifi-or-Ethernet-Configuration

Will happily take any input if people have better settings.