Duet 2 Wifi Z Movement Wrong
-
Hi all,
I'm setting up a duet 2 wifi on a CR10s5, everything is mostly working but the movement of the z axis is out by a factor of 10, so if i tell it to move 5mm, it moves 50mm and if i say 50mm it moves 500mm etc. Also the tool position doesn't update in the dashboard.
X and Y axis are spot on and tool postition shows correctly.
Board: Duet WiFi 1.02 or later
Firmware: RepRapFirmware for Duet 2 WiFi/Ethernet 3.0 (2020-01-03b3)
Duet WiFi Server Version: 1.23Thanks
-
What is the pitch of you lead screws?
Can you show us a copy of your config where you setup your steps/mm for the Z-axis.
-
@ashtonwatts Most likely you've got your steps per mm set to M92 Z4000. Should be Z400.
Ian
-
@droftarts That's exactly what i've got. Sorted, thankyou.