GL-8H endstop on Sidewinder X1
-
I am attempting to convert an Evnovo Sidewinder X1. The endstops used are Sunx GL-8H types, which according to Panasonic, the new owners of Sunx, are inductive sensors that require 12-24V supply voltage. Would these work on a Duet Maestro if I connect the VIN pin for the probe to the 24V supply? The input pin is documented to work up to 30V and should be able to handle it?
-
Thinking about this some more, the sensors work fine on the original MKS Gen L board, which provides 5V to the VIN pin of the sensor. So 5V from e.g. the PanelDue connector should suffice, correct?
-
@ofliduet Confirmed. Using the 5V supply from the Z Probe connector, the GL-8H sensor works. One axis homed, two to go.
-
Can you share your Settings for the Endstops with me ? I am using the same but they dont work for me atm with 5V
-
@d0minik96 How do you have them wired? How are they configured?
-
@Phaedrux i posted my answer in my thread i opened before
