Messed up Duet 2 WiFi WiFi/Firmware.
-
These may help.
https://duet3d.dozuki.com/#Section_Getting_started_with_the_Duet_2_WiFi_or_Ethernet
https://duet3d.dozuki.com/Wiki/Installing_and_Updating_Firmware
For the SD card, you'll need to rename one of those sys-printertype folders to just sys. Or use the web configurator to create a custom set of config files.
-
@bearer it does.....
-
@bearer Shows up as Duet WiFi...
-
@helensdad said in Messed up Duet 2 WiFi WiFi/Firmware.:
@bearer Shows up as Duet WiFi...
Then you didn't erase the firmware, it shows up as the Bossa device if it doesn't have firmware. But the links provided by Phaedrux should get you going.
-
Are you still able to connect to it with YAT?
-
YAT connects, I can set up WiFi and all is good. I then go to 'step 9' in the getting started routine and try and connect to the web interface and get access denied message.
-
I think you might be missing the Web Control files in the WWW folder, or have ones that are out of date. See here: https://duet3d.dozuki.com/Guide/Ender+3+Pro+and+Duet+Maestro+Guide+Part+2:+Configuration/38#s138
-
Thanks I will try that later. I am not using a Duet Maestro, I have Duet2 WiFi and I am using it to run a cnc router. I have access to the cnc firmware but can't get to the web interface....
-
@helensdad right but the step I linked to describes how to get the web control files installed in the SD card and how to connect after
-
Ok, many thanks....
