Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
undefined
Can you post your M558 line? You should be using P8 with a threshold of 500, the signal range is between 0 and 1000.
Can you tune the Uni v2.75 so that the blue led is lit and then see what the reported value is?
Idris
@phaedrux
I believe you are right. Disabling mesh does not change the Z value.
Thanks!
@toskium I've replied to your email, I'll send you a replacement PCB today.
