@botanic2000 said in G92 not working for E axis:

Has run into same issue with E-axis today. Was trying to set up print resuming after power loss and found out that RRF is ignoring G92 command in the "resurrect.g" file.
Basically, what happens is when I resume printing after power down the print head goes over the print and then it starts extruding all the way from 0 to the value that has been stored in "resurrect.g".

What am I doing wrong here?

Firmware Version: 2.01(RTOS) (2018-07-26b2)

1_1537273182573_resurrect-prologue.g 0_1537273182573_resurrect.g

Please post the ResTest.gcode file too, or put it on a file sharing site so that I can download it.