@spodeopieter said in No communication after erase button pressed:

3.3 v rail seems good , the SAM chip is getting a little hot , around 40 degrees , the esp is ice cold.

Just another thing I noticed , if I press the erase or reset button , nothing happens , no flashing of any LED's

The SAM shouldn't get hot if it's just waiting to be flashed. Perhaps it is faulty.

Once the chip is erased and waiting to be bootloaded, I wouldn't expect the Erase or Reset buttons to flash any LEDs.

It's possible in theory to program the processor via the PanelDue port (and for the same reason, having a PanelDue connected might interfere with programming over USB, although in practice it doesn't seem to). You would need Bossa or SAM-BA and a serial-to-UART converter with 3.3V signal levels.