Print Stopped 70% of the way?
-
Hello,
I've had an overnight print on and it was working fine. But it's just stopped, the web UI isn't showing anything and isn't listing the Job Status. I'd say the Duet has rebooted by the looks of it?
What's the best course of action to resume the print?
-
If something like this happens the best course of action is to run M122 to get a diagnostics report that might include some useful information. The results get cleared after a reboot, so it's best to do it before power cycling it if possible.
Were there any error messages in the gcode console?
To resume a print you'll have had to go through the required configuration first: https://duet3d.dozuki.com/Wiki/Setting_up_to_resume_a_print_after_a_power_failure
