40mm fan for Smart effector
-
all except for the aquarium pump yes you will need a peristaltic type pump that can shift at least 5l/min at a high back pressure
such as the BerdAir system from Makerhive -
Sunon fan 12v but buck converter just £3, £4 with led display. Can pwm the fan negative its well documented here. https://uk.rs-online.com/mobile/p/axial-fans/7588361/
I'm using watercooling for hotend 120mm fan running at 10% normally can't even hear it and twin 30mm blowers which I sell in my shop see my signature.
-
I got some Sunon Fans both 30mm and 40 mm for not to much cash from a firm in poland they arrived in about 36 hours 4 fans cost 20quid inc carriage etc.
company called TME
fan part numbers were HA30101V3-A99 and HA40101V4 carrier were DHL air
HTH they are super quite by the way.
Doug
-
I'm using a 40mm Noctua on the smart effector using this mount:
-
Hi Simon,
could you pls post some details on your water cooled combo with 30mm blowers on a smart effector setup?
thanks!
-
-
Traditionally the fan mounts on the e3d aluminium heatsink.
Is there any drawback if it was designed in a way that is integrated with the part cooling fan mount which relies on the ball stud screw, instead of snapping the mount onto the aluminium heatsink? I can leave a 1mm gap between the fan mount and aluminium fins to prevent the fan mount from interfering with the sensor but I'm trying to think if there is any drawbacks doing this. -
anyone got some links or pics from the aquarium air pump mod? Just looked unter the table where the printer is and found a refrigerator compressor i used for airbrush..abslut silent and way enough airflow
-
anyone got some links or pics from the aquarium air pump mod? Just looked unter the table where the printer is and found a refrigerator compressor i used for airbrush..abslut silent and way enough airflow
There's a product called the Berd'air
http://www.themakerhive.com/shop/viewitem.php?productid=45other informations:
http://forums.reprap.org/read.php?1,735688
http://forums.reprap.org/read.php?4,193532,193532
http://blog.lincomatic.com/?p=1531 -
I'm using a 40mm Noctua on the smart effector using this mount:
I used this same mount except there is an extended version on the same page. It has been working great for several months now and I even printed it in PLA.
