Duet 2 Ethernet not connecting

oliof

@Muhammed if you connect via YAT, the MAC address will be in the report generated by the M122 command.

Muhammed

@oliof Thank you.

I used M540 command and found the MAC address, I have assigned the IP address as well.

I can see the device on the network with the assigned IP, but when I try to ping it, all the packets get lost. When I try to connect to it through the local server GUI provided by Duet using the web sockets, its not getting connected as well.

Are there any other commands needed to start the network communication?

oliof

@Muhammed best to share your config.g

droftarts

@Muhammed Make sure you enable HTTP with M586:

M586 P0 S1 ; enable HTTP

Ian

Muhammed

@oliof @droftarts Hello
Here are the contents of my config.g files

; Default config.g template for Duet 2 tested with RRF3.4.5 stable 2022-11-30
; Replace this with a proper configuration file (e.g from https://configtool.reprapfirmware.org)


;enable UART for testing
M575 P1 B57600 S1

; test network enable
M552 P192.168.1.14
M552 S1

; Display initial welcome message
M291 P"Please go to <a href=""https://www.duet3d.com/StartHere"" target=""_blank"">this</a> page for further instructions on how to set it up." R"Welcome to your new Duet 2!" S1 T0

droftarts

@Muhammed Actually, HTTP should be enabled by default, so ping should work. Send M586 from YAT to check what services are running.

Check the IP address you are giving the Duet is within the IP range of the network, or use M552 P0.0.0.0 to use DHCP to set one.

Ian

Muhammed

@droftarts Hi, We have the service running but ping is still not working

M586
CORS enabled for site '*'
HTTP is enabled on port 80
FTP is disabled
TELNET is disabled
ok

droftarts

@Muhammed I would tend to think, if you're seeing the Duet in the router, that the IP address is out of range, or shared with another device. Can you not set an IP address with DHCP?

It's also possible that you router doesn't allow new device connections without adding devices to a 'safe' list.

Ian

Muhammed

@droftarts We enabled HTTP and CORS then we let DHCP assign the IP and now its working fine!.

Thank you everyone.

droftarts

@Muhammed What IP address did it assign? Having Cross-Origin Resource Sharing (CORS) enabled or disabled shouldn't make any difference.

Ian

Muhammed

@droftarts The IP address was assigned by DHCP

droftarts

@Muhammed said in Duet 2 Ethernet not connecting:

@droftarts The IP address was assigned by DHCP

Yes, but what IP address was assigned? I'm interested if it was in the same domain range, ie 192.168.1.xx, or something else. Send M552 to report the IP address. It's also possible the netmask is different from the default of 255.255.255.0. Send M553 to report the current netmask in use.

Ian

Muhammed

@droftarts Yes, it was the same. 192.168.1.120

Muhammed

@droftarts Can I ask if there is a way to connect the Duet Ethernet card directly to my PC and use the web interface? Thanks again.

droftarts

@Muhammed yes, see https://docs.duet3d.com/en/User_manual/Machine_configuration/Networking#wired-direct-connection

Ian

Muhammed

@droftarts Thanks alot. This was really helpful.