Web Interface Freeze After Auto-Calibration
-
Hi all!
I just finished re-building my Rostock with a new Duet Wifi, 0.9° steppers, and a 24V power supply.
Everything is working perfectly and the improvement in print quality over the stock 1.8° steppers that came stock with the Rostock is incredible, especially when printing at small layer heights.
The only issue I am having is that the web interface freezes after the auto-calibration completes and tries to pull up the height map. The same thing happens if I try to load the height map and view it after reloading the web interface.
Any ideas as to what may be causing this issue?
Thanks ahead of time!
-
What browser and firmware versions are you using?
-
that is very similar to what I am getting but only on mesh bed see my post on this running latest RC2 versions
-
I have the same Issue everything is ok but when i Calibrate i cannot connect to my Printer but im able to print though i cannot see the status nor reconnect to the printer.
-
sorry for hijacking this happens with Chrome Firefox and even with Edge
Runningits FW RC2
Wifi Beta10 i believe
and RC3 Webclient -
Thanks for all of the responses and sorry for the delayed response!
I am using firmware and wifi version 1.19 and web interface 1.15a and using Google Chrome, but the same errors present in Internet Explorer as well.
It appears that I was having an occasional probing error that was causing some of the errors, and I have fixed that issue. At this point, I can run the auto-calibration and the web interface will not freeze and the G-code console will report the adjustment, but when I try to load the heightmap the web interface will still freeze.
Thoughts?
-
your web interface (DWC) version is old.
Upgrade to latest firmware/DWC version (1.20) -
Thanks, that did the trick!