Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Duet 3 Tool Distribution Board

General Discussion

2

3

88

Log in to reply

undefined

SonnyD1
last edited by

Do I need a Duet 3 Tool Distribution board to run two Duet 3 Roto Toolboards from a Duet 3 Mini 5+? For an IDEX using two Rotos for example.
undefined 1 Reply Last reply
Reply Quote 0
undefined

T3P3Tony administrators @SonnyD1
last edited by

@SonnyD1 you do not, you an daisy chain them without the tool distribution board. or, if the stubs are short enough (~1m) then connect them both as stubs.
www.duet3d.com
undefined 1 Reply Last reply
Reply Quote 0
undefined

SonnyD1 @T3P3Tony
last edited by

@T3P3Tony Ok outstanding. Thank you!
1 Reply Last reply
Reply Quote 0

1 / 1