Inconsistent track width

Avamander

Is this inconsistency intended on the old 0.8.5 board (screenshot of Duet0.85.brd)?

T3P3Tony

Woops, that's an error in the old board design. Is it in the Gerbers as well?

Have a go with fitting it all into 3 layers. TBH I never considered a 3 layer board as that's pretty non standard. You need a good ground plane though.

May I ask what your plans are?

Avamander

Is it in the Gerbers as well?
Haven't checked.

May I ask what your plans are?
Just thought for a moment about rolling with my own board, because paying more than a 2 hundred $ just sounded too steep for me so I was looking at if I could save some cost. Adding it all up (including time I'd have to spend to learn how to redesign the board to 3(or even more extreme 2)-layers without errors) I realized it's not worth it.

EDIT: Clarified my sentence

T3P3Tony

Fair enough

I would be pretty surprised if anyone managed to make it fit on 2 layers. Also that would remove the ground plane which would be a bad idea.

Avamander

@T3P3Tony:

Fair enough

I would be pretty surprised if anyone managed to make it fit on 2 layers. Also that would remove the ground plane which would be a bad idea.

Would most likely mean just quite a "few" 0ohm resistors and a larger sized board (which isn't bad in terms of heat dissipation though).