Motors step loss
-
Hi,
i have finished my Duet conversion, a Delta Tevo Little Monster….
After some prints of small objects, i have I have tried to print an object of intermediate size, and it has not gone well.
What happened to me?
The previous impressions, small objects have gone well but when I tried an object of intermediate size.
The object has begun to print well, I have used PLA at speeds I think it drops about 3000mm / min.
After about 20/25 layers, 3 layers per millimeter. The layers have started to move, maybe 1 mm or 2 mm.
I have discarded, I think, the mechanical problems one thing that I would fail to check is if the voltages of the motors are correct .... but I do not know how to look at it.
Another thing, I do not know if it will be possible, it sounds to me that in the last versions of the Firmware, there is a control of loss of steps, but I do not know how to use it.
Any idea where can I start?
