Configuring Stepper Motors

Andrew_15

I have planned to make connection as per the above circuit diagram. But when I to config 4 motors for the Z axis, the RepRap firmware just allows me to config only one motor for one axis. How do I config all these motors

RepRap Config

Phaedrux

The config tool is currently limited to assign a single motor per axis. You need to configure the motor mappings manually in config.g afterwards.

https://docs.duet3d.com/User_manual/Reference/Gcodes#m584-set-drive-mapping

jay_s_uk

@Andrew_15 or use the new beta config tool
https://configtool.reprapfirmware.org/next/