Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Gcode upload problem on linux

    General Discussion
    2
    3
    144
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • DuetUserundefined
      DuetUser
      last edited by

      I cannot reliably upload a g-code file via DWC on a Linux Mint 21 machine. It starts and after proceeding for a while the connection goes down and upload fails. The printers have Duet 6HC boards with 3.4 firmware. Uploading from W10K works normally, only on Mint it fails, I tried Firefox and Brave, same result, no matter what connection settings are in the DWC. Perhaps there are some networking settings I don't know about. Did you have any problems alike?

      peter

      1 Reply Last reply Reply Quote 0
      • Phaedruxundefined
        Phaedrux Moderator
        last edited by

        Wired or wireless?

        Z-Bot CoreXY Build | Thingiverse Profile

        DuetUserundefined 1 Reply Last reply Reply Quote 0
        • DuetUserundefined
          DuetUser @Phaedrux
          last edited by

          @Phaedrux
          Always wired.

          peter

          1 Reply Last reply Reply Quote 0
          • First post
            Last post
          Unless otherwise noted, all forum content is licensed under CC-BY-SA