Getting phase errors for extruder motor
-
I also get this error when nothing is plugged into the drivers
-
@bwenig said in Getting phase errors for extruder motor:
I mapped the extruder to another driver and got the same error.
So it follows the motor and the driver?
Did the new motor you tried on the new driver use the same wiring?
So you have two drivers now that are not working?
So which drivers are the ones having a problem?
Have you tried one of the drivers that is currently working on one of the existing axis like X?
@bwenig said in Getting phase errors for extruder motor:
E15360.00
This is a very high steps per mm. What kind of extruder is this?
Can you post some photos of the driver chips?
-
@Phaedrux
Yes, it follows the motor and driver.
Yes I used the same wiring, and tried switching the A and B as well/
So now I have two drivers not working: E0 and E1.
I am hesitant to try the motor on a working axis! But I will test it now.I am using a Replistruder. I got the config.g file from a research paper.
Here are some pics of the board:
-
@bwenig said in Getting phase errors for extruder motor:
I used the same wiring
You should use new wiring.
-
So plugging the extruder motor into the x axis results in the same error, but I heard some clicking out of the motor, it tried to move a little bit.
I plugged the x driver back into the x motor and luckily everything still works fine.
-
@bwenig said in Getting phase errors for extruder motor:
I am using a Replistruder. I got the config.g file from a research paper.
I don't know what that is, but 16000 steps per mm is insanely high. How fast are you trying to command the extruder to move?
-
@Phaedrux My extruder has very fine movement, so I think 160000 steps might not be too bad? Here's a video of me moving it manually:
-
Well it may limit speed.
-
@Phaedrux Should I try a much smaller E value? Not sure what else I could try to get these drivers to cooperate
-
Do the drivers work if you move the X/Y axis to them and remap?
-
@Phaedrux No, they throw the same phase errors
-
And if you put the X/Y motors on the drivers you were using for the extruder and remap do they work there?
