Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Delta X0 Y0

    Scheduled Pinned Locked Moved
    General Discussion
    1
    2
    379
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Edkirkundefined
      Edkirk
      last edited by

      Just finished my first DIY Delta and printing first print. I see the Delta "machine" X0 and Y0 is located in the center of the round bed and the slicer software, Simplify 3D, is also in the center of the bed. When the print starts it moves to the rear right of the bed to start printing at the edge of the print bed. I sort of solved the issue by entering a X-90 and Y-90 offset in S3D G Code. Is there a setting in config.h to compensate for the offset?

      Thanks, Ed

      1 Reply Last reply Reply Quote 0
      • Edkirkundefined
        Edkirk
        last edited by

        I found the solution in S3D, I was in the correct area but going the wrong direction.

        Thanks, Ed

        1 Reply Last reply Reply Quote 0
        • First post
          Last post
        Unless otherwise noted, all forum content is licensed under CC-BY-SA