I think I got a defective tool board
-
Please share your full config.g and the results of sending M122 and M122 B# where # is the can address of the toolboard.
-
This post is deleted! -
@kiendeleo I deleted my first comment, but looking at that, it seems your thermistor cable is shorting itself. Either that or your boron paste is still wet.
-
@ctilley79 It’s happening with the thermistor unplugged.
-
-
Can you try adding a G4 S4 command near the top of the config.g? This will add a short pause at startup to allow the toolboard to boot fully before sending it commands.
Also can you send M98 P"config.g" and post the results?
-
@phaedrux M98 P"config.g" did not create a result in the console
-
That's a good sign.
-
@phaedrux Well, I might have figured out what this might be.... @ctilley79's comment made me think so I unplugged everything except the thermistor and heater cartridge, and now the thermistor is responding correctly... weird
-
It looks like the issue was a reversed power and ground wire on my magnetic filament monitor.
-
undefined Phaedrux marked this topic as a question
-
undefined Phaedrux has marked this topic as solved
