Finish putting screws and crimping... It's just the beginning
-
I am finishing assembling the printer, the next step, after checking that everything works as it should, will be to adjust the parameters...
I've been looking around the forum/documentation.... And my I have found countless parameters to adjust, and not only that, but also, some are related, or depend on others
In your Workflow:
- In what order do you adjust the parameters
- Which parameters it is advisable to adjust
I put some that I can think of, without any order
- Motors steps per mm
- printer movement type
- printer dimensions
- end stops
- z probe
- jerk
- acceleration
- pressure in advance
- volumetric extrusión
- calibrate bed temperature control
- calibrate nozzle temperature control
- retraction speed
- retraction distance
- dimensional accuracy (motor steps?)
- calibration/compensation bed
Please indicate the ones you recommend adjusting...
Thx
