Voron V0.1 issue

tecno

Not so loose. I now have no-name belt and cheapo chinesium pulleys.

V0.1 config?? please elaborate if you have time.

PaulHew

@tecno Printer.cfg is what I meant in regards to 'Config'
The speeds you are running do not look extreme, from the video you posted.

Only other thought you could be running close to the bed and the nozzle is catching slightly, which can cause layer shift.

P.

tecno

Will try to raise the nozzle and see if that can be the issue, but first layer looks just fine.

I'll be back

tecno

Sorry same problem still

alankilian

@tecno As an experiment, take out any filament and start a print and see if you still get layer shift.

This will allow you to eliminate the possibility it's the extruder catching on part of the print.

From what I'm seeing, it seems like it's mechanical and I expect you'll still hear the jumps and see a layer shift.

tecno

Still same problem

zapta

@tecno, try printing without filament and without a belt?

May indicate if the controller sends something funny.

tecno

Actually I think I've found the issue.

Belts too tight
re level the bed = was too close obviously. Done at 60°C
Still some hard clonk noise that I think is bad linear bearing . Will regrease from outside.

This was driving me crazy but now I think this can work.

I hope this can be helpful to others.

Cheers
Bengt

tecno

First print, not 100% but close enough so I am a happy camper

tecno

Printer ready built