Problem with mesh compensation
-
M208 X0 Y0 Z-2 S1 -
-
Looks like it is working OK now.
Thanks again for lending out your eyes
-
@tecno your mesh looks a bit odd to me with the two 'pits'. Does that represent the bed or something within the gantry?
-
Bed, unfortunately Chiron's beds are too thin and warp easily. This is my second bed, got the replaced on warranty.
No longer I use the original glasbed, now PRIMACREATOR FLEXPLATE-POWDER COATED PEI.
Printing PETG on backside with gluestick, sticks way too good on PEI. -
@blacksheep99 said in Problem with mesh compensation:
@tecno your mesh looks a bit odd to me with the two 'pits'. Does that represent the bed or something within the gantry?
Re pits. My theory is that my printsurface with glue is not optimal for IR probe so those pits may very well be reflections of said combination.
-
@tecno sounds like you’ve well versed in the challenges of your printer then. Hopefully your current prints come out well
-
@blacksheep99
Trying my best to get a grip of things around my toys
Now in the morning print is at 75%, so I am pleased.
-
Well print time from S3D said 13h24 and just finished at approx 24h.
Issue with X axis belt tension, this is a mofified Chiron with linear guides and used parts from Thingiverse that apparently are not up to the task as X axis motor gets hot and belt slacks as PETG part gets warm.
Back to the drawingboard
Fix X axis and reprint parts. -
X axis fixed and a testprint on its way. Will start a small batch over night print.
Looking very good.
