ToolBoard and Magnetic Sensor

[metty]

Hello all!
I made the error, and just connected them with a cable like on this Picture:
https://duet3d.dozuki.com/Wiki/Duet_3_Tool_Board#Section_Connecting_a_filament_monitor

Only when it didn't work did I see that the connector on my Magetic sensor board is soldered on in reverse. Would be helpful to have an actual picture or a polarity warning on the website. I was certainly not very smart to make and connect the cables blindly as in the picture. But I thought, if there is already such a nice picture, it will surely be right.

One of my four toolboards is offline now.. I am currently analyzing why exactly. I hope no hardware was broken cause of the wrong connection.
Edit: Somehow it reset the CAN address. The toolboard is now online again..

[T3P3Tony]

@metty thanks for pointing that out. I have updated the picture and also added a note that different versions of the Magnetic Filament monitor had different pinouts.

[metty]

@t3p3tony I have to thank you! Luckily nothing was broken.