Delta Frame Compensation
-
This ones for the Devs...
1: I am aware of your G32 command obviously as I run this before each print. First question is... can i save the values from the G32 command so i dont have to run this before every print??
2: Is it possible for me to be able to save G28 bed maps at different temperatures so i can save these for use with different materials?
3: Delta frames comming from china are not great as you would expect. I would like a way of fully compensating for frame miss-alignments. If i were to print a 2D square on the build plate (as large as the build plate will allow) this will not quite come out square. If i had the ability to peel this single layer square off the build plate, and compare it to a scale printed square on a piece of paper i could get a decent measurement of how far out the square is from being streight. It should then be possible to put xy offsets into the firmware to compensate.
Any or all of these might be possible... if not i would really like the functionality.
Thanks.!
-
@haydenkrause - these are all Delta oriented questions - sorry - not clear above
-
1 - Use M500 to save the G32 results
2 - Yes https://forum.duet3d.com/topic/22636/macro-to-call-heaight-map-based-on-bed-temp
3 - Not sure on this one -
@jay_s_uk maybe you find some solution there: https://duet3d.dozuki.com/Wiki/Gcode#Section_M556_Axis_skew_compensation
-
@haydenkrause lso, there's a fairly complete description of calibrating a Delta machine at THIS link.
-
@philipp-r - thanks i will look into this when i get a chance!