Lack of extrusion?
-
@ctrdevelopments what retraction are you running on the Hemera? It barely needs any at all. Mine is at 0.2mm as an example.
-
@blacksheep99 so, I am using 1.4 mm retraction, I can try lowering that (35mm/s speed also)
@Phaedrux yes, I have that selected, again I will try that
I have just started a 2 days print so will tweak after that
many thanks both
Cheers
-
@ctrdevelopments That’s way too much for a Hemera. I run the same speed. Try 0.3mm and see if that helps. You can tune from there if needs be.
-
So, retraction at 0.3 got probably 90% of the way there. Will try the perimeters next
-
@ctrdevelopments Good to hear. The other thing to check is the tension on the filament. It’s hard to tell on the Hemera.
-
@blacksheep99 OK, so perimeters have now eradicated it completely. I am however getting a bleed through of the infill into the outer walls. I am printing 3 outer walls (0.8mm nozzle) and only 5% infill (the wavy prusa slicer one). I didnt have this before but not sure if it is linked to the changes or not as I have swapped to fiberlogy filament as I ran out of the 3DFilaprint PETG large spools
-
@ctrdevelopments what's your overlap percentage in PS?
-
@blacksheep99 25%
-
Try 20% instead. Also I'm not sure which infill type you mean. Perhaps choose something more standard like rectilinear, or grid, or cubic.
-
@phaedrux 20% was much improved. I am now going to try 18% as still some very slight marks. The prints take a few days each so feedback is not the fastest, but it is a good test. Thanks for help