G10 hardware retraction and z-hop

garyd9

Assuming hardware retraction is set up with a non-zero "S" and "Z" parameter, in what order does RRF perform the retraction and hop when G10 is encountered?

Retract, then hop? Both the retract and hop at the same time?

Phaedrux

I believe it's retract then hop.

Yup: https://forum.duet3d.com/post/201684

garyd9

@Phaedrux said in G10 hardware retraction and z-hop:

I believe it's retract then hop.

Yup: https://forum.duet3d.com/post/201684

thanks - I've submitted an edit to https://duet3d.dozuki.com/Wiki/Gcode#Section_G10_Retract (and G11) clarifying the order.

"Retracts filament then performs any zlift/hop according to settings of M207."

"Unretracts/recovers filament after undoing any zlift/hop according to settings of M207."

(The "zlift/hop" term is taken from M207. )