(Resume print after shutdown power)
-
Hello,
I want to know if it's possible to resume a print after a shutdown power ? If yes, how ?
If it's unpossible, does a system exist to use an inverter with a digital input to inform the board of the power switching ? which will allow to cut heatbed or other heavy devices for exemple.
Thank you so much,
Rodrigue
-
https://duet3d.dozuki.com/Wiki/Setting_up_to_resume_a_print_after_a_power_failure
So sure how up to date that one is so also check:
https://duet3d.dozuki.com/Wiki/Gcode#Section_M916_Resume_print_after_power_failure
If you have something that will give the Duet advanced warning of power failure then you can use that to switch and input pin, tied to a trigger, to run a macro which could turn off the bed etc then pause the print.
-
Thanks for your reply. It's little bit complexe for me but i nothing is unpossible !
