Faulty Smart Effector

Veti

try changing the sensitivity

https://duet3d.dozuki.com/Wiki/Smart_effector_and_carriage_adapters_for_delta_printer#Section_Programming_the_sensitivity

tcj

Thanks, but that is not the only thing that I tried several times but without any success.

Veti

post high resolution pictures of the front and back of the effector

tcj

I've already inspected the whole effector with a magnifying glass
There is nothing abnormally

Phaedrux

When and where did you purchase it?

tcj

Sep '19 at filafarm.de
I've already sent them a mail

Phaedrux

Photos? Maybe we can see something you can't?
Wiring?
Did anything change recently with the printer?
When was it working last?

tcj

Wiring is ok - worked for months
Updated RRF a few days ago, but not yesterday
Working last night at last

Phaedrux

Is that a scratch on the second photo on the bottom edge?

tcj

yes, but it's there since I received it and it is only on the lacquer coat

Phaedrux

What M672 are you using?

tcj

tried M672 S131:131 without success - even no flashing of the LED

and before you're asking

;### Z-Probe ###
M558 P8 R0.2 F1200 H2 C"zprobe.in"
G31 P100 X0 Y0 Z-0.19           		; Set Z probe trigger value, offset and trigger height             
M557 R180 S40                          		; Define mesh grid

Veti

@tcj said in Faulty Smart Effector:

M558 P8 R0.2 F1200 H2 C"zprobe.in"

this is missing the zprobe.mod to control the sensitivity

try C"zprobe.in+zprobe.mod"

tcj

@Veti

tcj

@Veti Thank you so much!
It works!

Lightpath

@Veti said in Faulty Smart Effector:

C"zprobe.in+zprobe.mod"

This should be in the documentation.

Phaedrux

@Lightpath said in Faulty Smart Effector:

@Veti said in Faulty Smart Effector:

C"zprobe.in+zprobe.mod"

This should be in the documentation.

Consider it done.