Endstop instantly triggered when homing (y-axis)
-
@fcwilt
It is for stealthchop. My machine used to be corexy
and I have not yet optimized/checked best values for stealthchop with the new kinematics. -
-
@Veti
It was set high as possible for silent movement.
I will try lower values, though 16x seems very low?
Can I use something like 64x or 128x?Main printer: 3-5 Axis, 400x400x450 Duet 6HC || https://grabcad.com/eetu-4/models
-
the driver interpolation will run them interally at x256
-
@Veti
I changed all microstepping to 16x and commented stealthchop related commands. This didn't change y-axis homing. It still seems to instantly "reach" endstop. After homing y-axis can be moved normally, though the position won't be correct.Main printer: 3-5 Axis, 400x400x450 Duet 6HC || https://grabcad.com/eetu-4/models
-
@Visionary said in Endstop instantly triggered when homing (y-axis):
changed all microstepping to 16x and commented stealthchop related commands.
M915 not M569
-
@Veti
That is also related to stealthchop according to some post. Stall detections doesn't work with stealthchop . -
what kind of endstop are you using?
-
@Veti
Regular normally open microswitches. I think ill change it just be sure because I have crashed into it few times.Main printer: 3-5 Axis, 400x400x450 Duet 6HC || https://grabcad.com/eetu-4/models
-
@Visionary said in Endstop instantly triggered when homing (y-axis):
@Veti
Regular normally open microswitches. I think ill change it just be sure because I have crashed into it few times.Can you wire them to use the NC connection - using the NO connection is discouraged.
Frederick
-
@fcwilt
That worked! thanks.
