Duet3+SBC+Pi Cam

MaxGyver

I would like to monitor my prints over the duet web interface. Since I am already using a Duet3+SBC I was wondering if the SBC can be used to stream the video of an attached PI Cam.

I have already tried this tutorial, but I was not able to get it running.
If someone could point me in the right direction it would be much appreciated

Cheers,
Mac

Phaedrux

Check out motion

https://motion-project.github.io/motion_config.html#top

Frederik

Hello,

i tried the same with my Raspberry Pi 3b+ and the new Pi Cam v2 with 8MP Sensor and the MakerHawk Wide Angle Lens 165°

I used this WebInterface:

https://github.com/silvanmelchior/RPi_Cam_Web_Interface

it works realy well, because you dont have to go in the Linux Terminal to change Camera Settings. It all works over the Duet Webcam Field.

I used port 8081 but that is up to your preferences.

Regards
Frederik

MaxGyver

@Phaedrux Thank you!
After trying about a dozen different tutorials on how to install and configure motion I found one that worked for me.

Motion setup tutorial

Cheers
Max