Duet 3 : No tool nor bed shown
-
@Veti With a complettely new copnfiguration strait from the generator I have the same behaviour
-
what version of the duet web control are you running?
-
@Veti
I'am a bit puzzled ...I have created a macro with my config.g.
And running the macro I get the tootls and heaters...
It' just give me this errors
I don't know why my config.g is ignored...
-
@Veti My duet web control is 3.1.1
-
Hum the macro is not saved in the micro SD ... I think the problem is from here ...
-
@Donpi If you're using SBC, you shouldn't have an SD card in the Duet! The O: directory is a virtual SD drive on the Raspberry Pi. See https://duet3d.dozuki.com/Wiki/Getting_Started_With_Duet_3#Section_Virtual_SD_card
Where is your config.g? On the SD card in the Duet, or on the Raspberry Pi?
Ian
TronXY X5S with Duet 3 MB6HC and Roto toolboard : Cartesian bed-slinger with Duet 3 Mini 5+ WiFi and 1LC : RRP Fisher Delta v1 with Duet 2 Maestro : Polargraph with Duet 2 WiFi
-
@droftarts
Of cours in the raspberry
There is no card on de Duet -
Hooo... could it be that the partition I see on windows is the one for the Duet in standalone mode.
And that the partition use by the Raspberry Bi is not visible on windows ? -
@Donpi said in Duet 3 : No tool nor bed shown:
Hooo... could it be that the partition I see on windows is the one for the Duet in standalone mode.
And that the partition use by the Raspberry Bi is not visible on windows ?Very likely!
Ian
-
All that for this ...
Sorry for the time lost
-
you are making the changes on the sd card in windows?
-
@Veti Yes
-
why are you not using the editor on the web interface?
-
@Veti Now I use IT
