SD extension via CONN_SD design questions
-
Hello all,
I want to make a SD card extension to plug into CONN_SD on Duet 2 wifi/eth, basically just extending the SPI signals 150-200mm to an SD socket.
I don't have much electronics design experience, so I have a couple basic questions if anybody knows:
-
Would any passive components be recommended at the SD socket when extending in this way?
-
Related to the Duet, would running a PanelDue via the 4-wire cable, and a separate SD extension (rather than using PanelDue SD slot) cause any trouble?
Here is a picture of what I have in mind: Imagine a cable connecting this to CONN_SD. (no SD card holder model is in KiCad so it only shows the pads and connector).
Any guidance is appreciated. Thanks!
-
-
Also, here is the schematic i have made (pardon the sideways power ports):