No Power in Hot End, Duet 2wifi

[amcutem]

Hello, my Delta was working for a while, then suddenly the hotend stopped working. I've replaced all the fuses and I don't know what else to do.

I keep getting a no change in temperature error and I've confirmed there's no output on the hotend terminal on the board.

Any help is great.

Thanks,

alex

[Phaedrux]

Sounds like maybe the heater mosfet has failed.

If you only have a single extruder, you could perhaps switch over to using the second heater ports.

[amcutem]

@Phaedrux I would like to do that. But how?

[Phaedrux]

Can you post your current config.g?

You'd change the wiring from E0 heater to E1 heater and then in your config you'd need to tell the firmware you've made that change.