Mini IR triggers too far
-
changed the probe to P8 but it behaves exactly as before.
-
@neckbreaker said in Mini IR triggers too far:
changed the probe to P8 but it behaves exactly as before.
how many times has the probe flashed during initialization?
-
4 times
-
maybe @dc42 can give some input here.
https://miscsolutions.wordpress.com/mini-height-sensor-board/
4 Flashes means analog mode, 2 Modes mean digital. -
where did you read about the initialization flashing? I didn't know that yet.
also I'm not sure how the sensor should know about how it's initialized since the signal pin is only an output pin iirc.
-
@neckbreaker said in Mini IR triggers too far:
where did you read about the initialization flashing? I didn't know that yet.
on the website i linked.
-
-
to enable the pullup resistor try
C"^zprobe.in"maybe that switches it to digital mode, this is just a wild guess based on what i understand from the website.
-
thanks for your effort @Veti I got it fixed again.
it seems that the electrolytic capacitor was slightly bent upwards so it didn't properly shield the IR light between LED and receiver. my guess is that somehow the shiny plastic housing reflected the light in an uncontrolled manner.
At least bending it down made it work again.
-
@neckbreaker
it would still be interesting how you would get the mini ir to change to the digital mode on a duet2.
just out of curiosity.
