Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Warning High Temperature reported by driver(s) 2

    General Discussion
    2
    4
    439
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Sculpt Fabricatorundefined
      Sculpt Fabricator
      last edited by

      We keep getting a warning over and over
      Warning High Temperature reported by driver(s) 2
      But we are not showing any faults and temperatures are good
      Is driver(s) 2, heater 2? or is this not the driver 2 but 2 drivers? and if so is there way to find out which drivers and how to fix the warning?
      MCU is running at 36C

      Duet WiFi 1.02 or later + DueX5 Firmware Version: 2.05 (2019-12-13b1)

      Thank You

      1 Reply Last reply Reply Quote 0
      • Vetiundefined
        Veti
        last edited by

        https://d17kynu4zpq5hy.cloudfront.net/igi/duet3d/4k56ZjaaAHrTJI6Z.huge

        drive 2 is the z stepper driver

        1 Reply Last reply Reply Quote 0
        • Sculpt Fabricatorundefined
          Sculpt Fabricator
          last edited by

          Do you know at what temperature they will give the warning? and without a thermistor is this something the board is reading through the motor wires or is it the connection at the board that is getting hot?

          1 Reply Last reply Reply Quote 0
          • Vetiundefined
            Veti
            last edited by

            the tmc driver has inbuild temperature sensing. i believe its around 100C

            basically if you can touch the chip and its to hot to touch, its a problem.

            1 Reply Last reply Reply Quote 0
            • First post
              Last post
            Unless otherwise noted, all forum content is licensed under CC-BY-SA