DWC 3.2Beta2 does not control heaters ; beta1 works
-
Duet2wifi 1.01 on single extruder delta, no sbc. After updating to the 3.2b2 package,extruder and bed heater do not work with dwc. On selecting a temperature the interface behaves normally, but the heaters do not work. Reverting dwc to beta1 restores normal response.
-
@Adrian52 I've noticed that there is a slight change in the way that temperature selection seems to work. In beta1 you just selected the temperature and it worked, in beta2 it seems you need to select the temperature and then hit enter and that for me triggers the heater change. Perhaps you could try and see if it works the same way for you?
-
@gloomyandy thanks that did it. A bit odd though.
-
Yes I'm not sure if it is a bug or not perhaps @chrishamm will comment.
-
Thanks for reporting this, I noticed the same issue yesterday and I'll fix it in the next software version.
