Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Unable to switch off retraction

General Discussion

1

2

85

Log in to reply

undefined

Touchthebitum
last edited by

Hello
I can't switch off retraction on Simplify 3d. I checked off all sections...
Is it linked to something in the firmware ?
Any ideas ?
Thanks
Sparkcube XL V 1.1 300x300x190, Radds, Raspberry, Keenovo silicone bedheat 220v, Big Booster Extruder, DIY building
BLV Cube 665mm Direct Drive with Duet3/SBC (RPi 4) Mosquito Magnum/Bond Tech Extruder/Vanadium Nozzle, Keenovo silicone bedheat 220v
undefined 1 Reply Last reply
Reply Quote 0
undefined

Touchthebitum @Touchthebitum
last edited by

@Touchthebitum
I decided to switch to Cura and it's awesome. I don't have problems anymore.
Problem solved
Sparkcube XL V 1.1 300x300x190, Radds, Raspberry, Keenovo silicone bedheat 220v, Big Booster Extruder, DIY building
BLV Cube 665mm Direct Drive with Duet3/SBC (RPi 4) Mosquito Magnum/Bond Tech Extruder/Vanadium Nozzle, Keenovo silicone bedheat 220v
1 Reply Last reply
Reply Quote 0

1 / 1