Homing Error

[tkdirp]

I am setting up the printer but when I try to home the X or Y-axis this keeps coming up

G28 X
Error: short to ground reported by driver(s) 0 1

Also, what is motor phase B?

[Phaedrux]

I think you may have the motor phases crossed on you motor plugs.

Check your phases like this: https://duet3d.dozuki.com/Wiki/Choosing_and_connecting_stepper_motors#Section_Identifying_the_stepper_motor_phases

[Phaedrux]

https://duet3d.dozuki.com/Wiki/FAQ#Section_I_get_this_error_message_Error_G0_G1_insufficient_axes_homed

That may explain the G0/G1 error.

[Phaedrux]

If none of that helps, share your config.g and homing files along with the output of M122.

[tkdirp]

@Phaedrux
Okay, I give it a go

[tkdirp]

@Phaedrux
The motor wires were connected incorrectly and I just disable the fan function in the RepRap firmware because I did not order the corresponding wires yet. Anyways, the homing of the x and y-axis works well now.
Thank you.