Extrusion Control on Web Console
-
I've reconfigured a new Duet 2 Ethernet today. On the previous Maestro I could extrude filament on the web console. I've loaded the new RRF 3 that was release today, as well as the new web console. think it is 2.1?? Any case.. The extrusion control is disable. Normally when temp was reached it went active.. I think im missing something. How does the load filament work - What is the purpose?
-
When you updated to RRF3 did you also make the needed changes to your config.g?
Given your adventure in your other thread I would perhaps caution you to stick with the 2.05.1 release for the time being unless you're up for some beta testing and troubleshooting with RRF3.
-
I'm sure my config.g is fine for v3. I did do the changes
-
I'm having the same issue since I updated from RRF 3.0 to 3.01-RC6 and to Web Control 2.1.0
-
@wcj97 I think that may have been fixed in DWC 2.1.1
-
works fine in DWC 2.1.1
-
It has been fixed. Thanx a mil.
