Laser filament sensor geometry
-
Hey all,
I'm designing a block to hold my laser filament sensor. I was reading the wiki and noticed they were mentioning different geometries for the back plate, and some draft angle for the opening where the laser shoots down.
Here's what I cad'd up.
Any input on it? It's a 15 degree draft angle and there's a small pyramid on the bottom to get rid of stray IR light. The filament edge is about 9mm away from the sensor. I have the filament path enlarged because I am using screw in bowden connectors. I don't have any black filament handy, but I'm printing it with orange to see if it works at all.
-
Moved to the filament monitor category.
Not sure about the geometry myself, but worth printing and testing anyway.
