bltouch v3.1 help😞
-
@Phaedrux all of the moving part
like a slug -
If you send the command to do the self-test does it run continuously until you interrupt it? or does it still fail with a flashing error?
How bout this for homeall then. Change these lines to add a feed rate and the G30 will first do a fast probe and then slower ones.
G1 X150 Y150 F6000 ; move probe to bed center. Change as needed. M558 F600 A1 ; Dive fast once G30 ; probe Z M558 F120 A10 ; Slow second dive with more accuracy G30 ; probe z again G1 X0 Y0 F6000 ; return to home position -
-
ooops forgot to say self test runs then stops after about 10
retract/deploy then stays solid red -
Yes that looks right
-
@jobesynoob1234 said in bltouch v3.1 help
:ooops forgot to say self test runs then stops after about 10
retract/deploy then stays solid redLooking at the BLTouch 3.1 manual it seems like self test is limited to 10 times now. So that's as expected.
-
@Phaedrux well it worked faster probed center 3 times this time before going home
so does this now mean i can sort my z offsets and G30 S1 should work 
-
Yes I think you're set now.
-
this all probably could have bean easier if i could have uploaded videos
-
I am soooo greatfull for all your help you have no idea how much stress you have wiped out
my fingers are crossed still thank you so much 
-
Glad it's working out now. I should have taken a closer look at your homing files sooner. That was definitely part of the confusion.
