PT100 daughter board

gabi68

Hi,

I ordered a duet wifi with a smart effector with PT100. Question is: do I need a PT100 daughter board?
If not how I can connect the effector to duet?

Thank you
Gabi

Phaedrux

Yes you will need the daughterboard to connect the PT100 to the Duet.

https://duet3d.dozuki.com/Wiki/Connecting_PT100_temperature_sensors

https://duet3d.dozuki.com/Wiki/Smart_effector_and_carriage_adapters_for_delta_printer

gabi68

@Phaedrux
Thanks. Ordered one just now.

gabi68

@Phaedrux
By any chance do you know what kind of heights the board will have with the PT100 on top. The reason I ask this is I have concerns about this will fit in the space under the the bed on an Anycubic Kossel linear plus.
On the other hand if you have any other suggestion where I should mount the boards I am all ears

Thank you
Gabi

deckingman

@gabi68 said in PT100 daughter board:

@Phaedrux
By any chance do you know what kind of heights the board will have with the PT100 on top. The reason I ask this is I have concerns about this will fit in the space under the the bed on an Anycubic Kossel linear plus.
On the other hand if you have any other suggestion where I should mount the boards I am all ears

Thank you
Gabi

I just measured one and from the main board PCB to the highest point of the PT100 board which is the top of the terminal blocks, is 21.1mm.

gabi68

@deckingman
Thank you